22.5" Dual Mount for Up To 4.5' Open Array Radar - Top for Sat Domes - Top Plate Required
Install your satdome, camera or other marine electronics above your radar using a Seaview Dual Mount. Doing this ensures maximum performance out of your electronics and eliminates radar interference. The bottom mounting plate is pre-drilled to fit all closed dome radars, while the top mounting plate is modular and sold separately. Oval hollow mast section allows for easy cable management.
Specifically designed to not take up a large amount of space results in the perfect solution where space saving is a must.
A Dual Mount gives your radar or satdome extra height clearance to tower above anything that could obstruct its view, while still maintaining a small footprint. This also allows for all electronic cables to pass through one hole for cleaner installation.
The lower platform is welded onto the main body of the mount. This platform comes pre-drilled for just about all open and closed dome radars. The above image shows a lower platform on a dual mount that’s for a closed dome radar. When selecting a Seaview dual mount be sure to check to make sure that the particular one you are looking at is for a closed dome radar or a open array radar. The dual mounts that are for an open array radar have an extended lower platform so that the antenna clears the main body of the mount.
Modular Top Plate
The top platform is where you bolt the Top Plate to. Seaview developed the Top Plate to make product selection easier for the customer and to enhance the look of these mounts. Long gone are the days of top plates with a bunch of holes in them. *Top Plate Sold Separately*
Ultimate Passage 2003-2023 All Rights Reserved.